Description
Disinfectant
Composition
Hydrogen Peroxide and Silver Ions
Dosage and Method of Use
A) Disinfection of Drinking Water:
-
For municipal (tap) water:
Add 3–5 mL of Nanocil Water per 1000 liters of drinking water throughout the period. -
For well water:
Add 30–50 mL of Nanocil Water per 1000 liters of drinking water throughout the period.
B) Disinfection of Water Lines Between Production Cycles (Control of Scale and Biofilm):
-
Use a 1–2% Nanocil solution in a static mode (closed system) for 2–4 hours throughout all water lines.
-
Then flush the system using compressed air and hot water.
-
Concrete surfaces of fish farming ponds, after harvesting and draining, should be disinfected with a 1–2% Nanocil solution.
Disinfection of Fish Eggs for Treatment of Fungal Infections
(Malachite Green Substitute):
-
Every 24, 48, or 72 hours, apply 100 ppm (equivalent to 10 mL of Nanocil Water per 100 liters of water).
-
Add the disinfectant to IV drip bags and adjust the flow rate so that the solution passes over the incubated eggs within one hour.
-
Disinfection should begin 24 hours after egg incubation and continue until 48 hours before eyeing.
-
Performing a preliminary test on a small number of eggs before starting treatment is recommended.
Precautions
-
When handling concentrated Nanocil, always use protective gloves. In case of skin contact, rinse immediately with plenty of water.
-
If concentrated Nanocil is accidentally ingested, give the person plenty of lukewarm water, do not induce vomiting, and seek medical attention immediately.
-
Keep the container upright and out of reach of children.
